- #SHOUTCAST DSP PLUG IN FOR WINAMP 5.666 INSTALL#
- #SHOUTCAST DSP PLUG IN FOR WINAMP 5.666 WINDOWS 10#
- #SHOUTCAST DSP PLUG IN FOR WINAMP 5.666 PASSWORD#
Our recommendation would be to use the "DirectSound output" or the "Nullsoft Crossfading Output" but for the purposes of this tutorial we will be using the DirectSound output. You do not want to select the options labeled "Nullsoft WMA Output plug-in" or "Nullsoft Disk Writer plug-in" as these will create copies of the songs you attempt to play in different file formats on your hard drive. If you select the standard "waveOut output", you will experience minor moments of silence in between songs. This part is pretty much up to you depending on the sound you want.
Now that you have opened the preferences dialogue, click on the item to the left side of the dialogue labeled "Output" under the Plug-ins category. You may also press CTRL-P on your keyboard. Right click on the title bar that reads "Winamp" and mouse over the menu labeled "Options" then click on the option labeled "Preferences".
#SHOUTCAST DSP PLUG IN FOR WINAMP 5.666 INSTALL#
Also install the Shoutcast DSP Plug-in - you should not have to close Winamp to perform the installation.īegin by loading Nullsoft Winamp. If you have not already done so, install Nullsoft Winamp and familiarize yourself with it.
If you do not have the above requirements, you may read on but you may experience problems other than those addressed in this tutorial. If you already have the above requirements, please continue in your reading. Internet Access: Although you can broadcast with a 56k internet connection, a DSL or Cable connection to the internet is recommended for optimal performance. Nullsoft Shoutcast Source DSP Plug-in for Winamp: Download
#SHOUTCAST DSP PLUG IN FOR WINAMP 5.666 WINDOWS 10#
Operating System: Windows Vista, Windows 7, Windows 8, Windows 10 In order to broadcast you should have the following components and/or software: 70 opt-3.To start off, let's make sure you have the essentials. Otherwise, you can contact our tech support department for further instructions. If you do not, double check that you've entered in all settings correctly and try again. If you do.Congratulations! You are now streaming. Lastly, click on the "Connect" button and check at the "Status" section above it You should see a connection time and bytes sent counting up.
#SHOUTCAST DSP PLUG IN FOR WINAMP 5.666 PASSWORD#
In the "Password" text box, enter in the password that your encoder will need to use in order to connect to the ShoutCast streaming server.Ĭlick on the check box next to "Automatic reconnection on connection failure", and change the "Reconnection timeout" to 5 seconds Please note that you DO NOT need to add an HTTP:// or In the "Port" text box, enter in the port number your stream will be connecting to the ShoutCast streaming server on. Next, in the "Address" text box, enter in the address of the streaming server you want your encoder to connect to. NOTE: If you are a new StreamGuys customer, the following information can be found in the new account set up letter we email to you once your account is ready to use.įirst, locate and click on the "Use SHOUTcast v1 mode." check box.
This is where you'll enter in the server information and credentials which will allow you to connect to the ShoutCast server you will be streaming to.